Loading...
Back
IQOS 3 Troubleshoot
Holder
Charger

Let's try the following steps

Check for any potential damage on your Power Adaptor or USB cable. If you identify any damage, try using a new set of adapator and cable. IQOS devices are intended for use only with official or authorized IQOS Power Adaptors for optimal charging.
Make sure your Pocket Charger is switched ON*. Plug it into a power outlet** for at least 20 minutes. We recommend a full recharge, which requires 2 hours. * Press the Pocket Charger’s button once and see if the lights turn on. If not, press and hold the button again, for 4 seconds. ** Laptop USB ports may not have enough power to charge your Pocket Charger if it is completely discharged.
Reset your Pocket Charger. Press and hold the button located on the Pocket Charger for 8 seconds. All lights will briefly turn ON and blink white to indicate your device has been reset.
Use an IQOS cleaning stick to clean the Holder’s connector (bottom part of the device). Make sure the Holder’s connector is completely dry. Place the Holder back inside the Pocket Charger (remember that the Holder’s magnetic connector should face down).
Additional Support